Setup guide

Dedicated Micros ©2006
63
DS2 Network Guide
6. Enter the callback prole in 0 and 1, this is the route the text message from the
Operator will take when sending a message back to the unit.
7. Enter the password to enable SMS commands to be initiated. This password will be
included in the text message from the Operator.
8. Select the advanced setup button to enter details on the GSM module that will be used
in the system.
9. Enter the service centre number, this is the network service centre number of the
mobile phone, this information can usually be found on the phone in Messages ->
Message Settings -> Prole -> Message Centre Number based on a Nokia phone
menu.
10. Enter the pin number for the SIM card (if applicable)
Note: If a pin has been set the number must be entered each time changes are made to this page
and is submitted (Save Settings).
11. Enter the GSM/SMS port number that will be used for this function to operate on.
12. Remember to save the conguration by selecting Save Settings!
Note: For conguration via the OSD refer to Appendix G where all menu options are described.
Function Description
Destination Number This is the GSM number for the mobile to receive the message.
The format should be entered in international format including the
country code and local area code.
Destination URL This can be the URL or the IP address of the SMS Server when
utilising SMS over TCP/IP. The messages will be sent over an
Ethernet link if present, alternatively it will be sent over the GSM
network.
SMS Server This will enable the unit to accept and log SMS messages.
Note: The Verbose option must not be enabled when this option is selected.