Setup guide
Dedicated Micros ©2006
49
DS2 Network Guide
When you’ve entered those elds remember to select under what circumstances you want to the
unit to dialout on (alarms, camera failures etc).
SET UP THE UNIT SERIAL PORT TO DIAL OUT
The system now has the dialout prole used to control the connection, and the information on which
number to call to. We now need to congure the serial port to use the TA (or modem).
1. Plug the TA into COM port 2.
2. Click on System->Serial Ports & Telemetry
3. Select Serial 2 (round dot) to edit these settings.
4. Use the drop down list select your type of TA (or modem).
Note: If your TA is not listed then contact Dedicated Micros Technical Support.
NOTE: We could just as easily replace the 2 ISDN TA’s (Terminal Adapters), with 2 modems for
PSTN rather than ISDN.
5. Click on the ‘Save’ icon on the bottom right of the screen.
6. Reset the unit
The unit is now congured for PPP dialout.
The PC at the other end of the connection needs to be congured to receive alarms from the PPP
link.
SETTING UP THE ARC PC/EDP TO ACCEPT INCOMING ALARMS