Setup guide

Dedicated Micros ©2006
48
DS2 Network Guide
# <Username & Profile Label> <Password> <Port> <Phone No> <IP Address Range> <Subnet Mask>
#
username password PPP_Link2 1234567890 10.0.0.1 255.255.255.0
username password PPP_Link1 1234567890 10.0.0.1 255.255.255.0
dm password Ether1 1234567890 10.0.0.1 255.255.255.0
#
Note: Any lines marked with a # are comment lines and will be ignored by the system.
To set up PPP to connect the unit to a PC, the PPP settings need to be edited:
Username & Prole Label Password Port Phone No IP Address Range Subnet Mask
username password PPP_Link2 1234567890 10.0.0.1 255.255.255.0
dialout secret PPP_Link1 12345 172.16.100.240 255.255.0.0
dm password Ether1 1234567890 10.0.0.1 255.255.255.0
4. The PPP_Link1 connection, which is the link used for dial out on alarm, has been
changed. Change the username and password to anything, as long as it is unique in
the list.
5. Enter the phone number that the unit has to dial, along with an IP range and subnet
mask.
Note:
The IP address in the table needs to be the address used by the PC within the target
network.
For example, the unit has a local network address range of 192.168.*.* but the PPP is
using 172.16.*.*. The unit PPP range in the proles le must be the same as whatever
is being used on the target network (in this case 172.16.*.*). The unit network address
should be on a different range to the PPP addressing scheme or else the unit will see
the alarm target is on the same LAN segment, and try to send the alarm via Ethernet,
even when the PPP session is established.
6. Save the edited PROFILES le back to the unit.
SET THE CONDITIONS UNDER WHICH THE UNIT WILL DIAL OUT
The unit now has the information it requires to establish a connection to an external PC. The next
step is to set up the hardware that will make the connection.
1. Click on Alarms/VMD -> Alarm/VMD Reporting.
2. To set up the primary connection, enter the IP address of the target PC running NetVu
ObserVer and the EDP in the ‘Host’ column.
3. In the ‘Prole’ column, enter the prole name created in the last step.
Note:
Use the correct username/prole label congured in the PROFILES le. This is how the
system knows which settings within the le to use.