Operating Instructions and Installation Instructions

AD Holdings ©2011
80
TransVu Express
Protect alarm Images Alarm images can automatically be protected from being overwritten .
Goto Preset It is possible to action a camera to automatically be sent to a preset
position when an alarm is triggered.
Email Reporting The unit can send an email when an alarm is detected, refer to
‘Network-E-mail’ for more information.
Alarm Rate Change Select to change to the alarm mode recording rate on zone action.
VMD/Activity Inhibit Select to inhibit (ignore) the VMD/Activity detection feature, refer to
‘Activity Setup’ for more information.
System Set Select to change to the ‘Set’ mode recording rate on zone action.
Relay Select an onboard or external relay to automatically close on receipt of
an alarm.
Relay Duration Enter (in seconds) how long the relay is to remain closed.
Alarm Image Snapshot Delay This gure allows a delay to be introduced before an alarm snapshot is
taken. This is used when the alarm relates to a PTZ camera which has
to travel to a preset position.
Play Audio Message Following a Zone alarm trigger, a specic audio message can be
played.
IMPORTANT: Audio messages must be uploaded to the unit in mono 8k wav format only.
The following naming convention must be used: messageXX.wav
i.e. message00.wav, message01.wav etc.
An FTP client should be used to place the wav les in the following folder:
\mdd0\messages folder .
Switch Main Monitor Select to display the alarm zone Primary camera on the Main Monitor.
System Override Select to change to the ‘Override’ mode recording rate on zone action.
Overlay Main Monitor ?????