Operating Instructions and Installation Instructions

124

TransVu Express

Repeat Timeout (ms) This setting stops the software reporting the same number

plate twice.

A repeat plate reading is not reported during the selected timeout

period. For example, a vehicle may be required to halt at an entry

checkpoint. If it is deemed acceptable that the vehicle should in

usual circumstances have cleared this checkpoint within 10 seconds,

10000ms should be entered to prevent the vehicle’s details being

reported again within this time period.

Note: The time is entered in milliseconds (ms).

Max plate size (pixels) A limit can be set for the maximum number of pixels within the

image that the target number plate assumes. Above this limit, the

ANPR software will not attempt to interpret the number plate. The

recommended maximum setting is 50000 pixels.

Min plate size (pixels) A limit can be set for the minimum number of pixels within the

image that the target number plate assumes. Below this limit, the

ANPR software will not attempt to interpret the number plate. The

recommended minimum setting is 1000 pixels.

Region The ANPR software can be congured to most effectively read the

various styles of number plates used throughout the world. It is

important that the software be congured for the standard number

plate format used in your territory. The appropriate region should be

selected along with a list of selected countries. Countries are added

to the Selected Countries list from the Available Countries list by using

the ‘>’ button.

Similarly countries are removed from the selected list using the ‘<’

button. All available countries can be added/removed via the ‘>>’ and

‘<<’ buttons. The list of countries can be reordered using the ‘+’ and ‘-’

buttons. The order determines the priority in which syntax checking is

applied when performing a plate reading.

Reset (Red) Select to reset the unit.

Refresh (Purple) Refreshes the information on the current page