Operating Instructions and Installation Instructions

AD Holdings ©2011
121
TransVu Express
Trigger Alarm When a trigger occurs, you can set the system to activate a Virtual
Alarm. Virtual Alarms can be used as an Input in an Alarm Zone.
Trigger Condition The Trigger Condition will generate an alarm depending on the
following parameters:
In Select ‘In’ to use the number o objects crossing the
tripwire in the direction of the arrow.
Out Select ‘Out’ to use the number of objects crossing
the tripwire in the opposite direction of the arrow.
Balance Select ‘Balance’ to use the total number of objects
which have crossed the tripwire in either direction
to identify the balance currently on the arrow facing
side of the tripwire.
> Select ‘>’ to trigger an alarm when a gure greater
than that identied in the Object Total textbox has
been reached.
>= Select ‘>=’ to trigger an alarm when a gure equal
to or greater than that identied in the Object Total
textbox has been reached.
= Select ‘=’ to trigger an alarm when a gure equal to
that identied in the Object Total textbox has been
reached.
< Select ‘<’ to trigger an alarm when a gure less
than that identied in the Object Total textbox has
been reached.
<= Select ‘<=’ to trigger an alarm when a gure equal
to or less than that identied in the Object Total
textbox has been reached.
Object Total Enter the required object total.
Examples: A setting of ‘In > 10’ would trigger an alarm when more than 10 people had crossed the
tripwire (in the direction of the arrow).
A setting of ‘Out <= 10’ would trigger an alarm when 10 or less people had crossed the
tripwire (in the opposite direction of the arrow).
A setting of ‘Balance > 10’ would trigger an alarm when a balance of more than 10
people are designated as currently being on the arrow facing side of the tripwire.
Current Status This details the current number of objects which have crossed the
tripwire in either direction. The balance of objects currently on the
arrow facing side of the tripwire is also shown. Please note that the ‘In’
and ‘Out’ totals can manually be overridden and new gures entered.
Entering new data here will change the Balance gure.
Reload Img (Red) Refreshes the camera view on the page
Count Status (Yellow) Displays the tripwire tally.
Refresh (Purple) Refreshes the information on the current page