Operating Instructions and Installation Instructions
AD Holdings ©2011
101
TransVu Express
E-mail
The unit can automatically transmit an e-mail to an SMTP Server under numerous conditions i.e. on
start up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmanned
applications where a Remote Video Response Centre (or Manager etc.) would be notied by e-mail
if any of these conditions occur.
Connection Prole It is possible for the e-mail to be transmitted via the Ethernet network
or dial up connection (PPP ‘Point to Point Protocol’). This setting
presumes that a modem has been connected or congured and the
unit is connected to a LAN or WAN and allocated a valid IP address.
Mail Server Address This is the IP address or URL of the SMTP Server that the e-mail will
be sent to. The SMTP server will then forward this to the intended
recipient.
Username If a username is required to access the mail server, enter it here.
Password If a password is required to access the mail server, enter it here.
Recipient Email This is the e-mail address of the intended recipient.
Display Name (Recipient) This is the addressee name that will be shown in the email name eld.
Reply to Email This eld must be congured if the recipient is to reply to an e-mail.
The unit does not accept incoming e-mails therefore ensure this is a
valid e-mail address.
Display Name (Reply To)
This is the ‘reply to’ name that will be shown in the email name eld.
Sender Email These optional elds indicate the source of the e-mail notication. If
the elds are left blank the unit will use the system name to create a
sender name.
Display Name (Sender)
This is the sender name that will be shown in the email name eld.
Send on Startup Select to send email notication on startup.