Operating instructions
Dedicated Micros ©2010
90
SD Advanced
Add Still Image This will record a still image of the trigger along with the standard
recording. This can then be sent on to an external destination.
Email Image If this option is selected, a JPEG will be added to the reporting
email (if Email Reporting is selected).
Protect alarm Images
Alarm images can automatically be protected from
being overwritten
.
Switch Spot Monitor Select to display the alarm zone Primary camera on the Spot
Monitor.
Goto Preset It is possible to action a camera to automatically be sent to a
preset position when an alarm is triggered.
Email Reporting The unit can send an email when an alarm is detected. Refer to
‘Network->Email’ for further information.
Alarm Rate Change Select to change to the alarm mode recording rate on zone action.
VMD/Activity Inhibit Select to inhibit (ignore) the VMD/Activity detection feature. Refer
to ‘Alarm Settings->Activity Setup’ for further information.
System Set Select to change to the ‘Set’ mode recording rate on zone action.
Enable Buzzer Select to activate the unit’s internal buzzer upon alarm receipt.
Relay Select an onboard or external relay to automatically close on
receipt of an alarm.
Relay Duration Enter (in seconds) how long the relay is to remain closed.
Alarm Image Snapshot Delay This gure allows a delay to be introduced before an alarm
snapshot is taken. This is used when the alarm relates to a PTZ
camera which has to travel to a preset position.
Play Audio Message Following a Zone alarm trigger, a specic audio message
can be played.
IMPORTANT: Audio messages must be uploaded to the unit in mono 8k wav format only.
The following naming convention must be used: messageXX.wav
i.e. message00.wav, message01.wav etc.
An FTP client should be used to place the wav les in the following folder:
\mdd0\messages folder .
Switch Main Monitor Select to display the alarm zone Primary camera on the
Main Monitor.
Cam Options (Yellow) Select to open the Zone Action Camera Conguration menu.