User guide

NetVu ObserVer

Double click on one of the cameras to display it in the selected segment in the ObserVer software. Alternatively,

the camera icon can be dragged and dropped into a segment to display it.

Navigate back to the top level of the map by right clicking on the map. In Multisite mode, it is possible to select

another of the sites from the top level.

Cameras from one image server can be displayed alongside images from different servers. When cameras from

different servers are shown onscreen, the map will automatically navigate back to the top level.

The Map Editor software is available as a free download from the Dedicated Micros website, and is located

within the Downloads section in the Support area (www.dedicatedmicros.com).

Common Controls

This section outlines the functionality that is common to both Live and Playback operating modes and explains

how the functionality corresponds to the buttons within NetVu Observer.

Camera Selection

Selecting a camera is achieved using the site tree, the site tree displays the Image Servers that are currently

being controlled as well as the enabled camera inputs on each server. Depending on whether the application is

in single-site mode or multi-site mode the following will apply.

To select a camera or cameras;

Single-site mode Clicking the mouse on the image server will result in input 1

of the unit being displayed (default), selecting a multiscreen

display will result in the consecutive images on the server

being cascaded in the multiscreen display - the number of

consecutive cameras will depend on the cameras enabled

and the display format selected.

Note:

If a multiscreen display has been selected in the Properties option when selecting the image

server, the application will display the multiscreen and cascade the cameras starting from

input 1.

Single and Multi-site Mode Highlight the required camera and ‘drag’ this to the position

on the screen where the camera is to be displayed, the

camera will be displayed in the full or multiscreen segment

selected, or

Single and Multi-site Mode Select a monitor position (if multiscreen is displayed) and

then double click the mouse on the camera, the images from

the camera will be displayed.