Installation guide

NV1

Installation Guide

Installing the Unit

Before you start

Check the contents of the box

Remove all items from the packaging and check the items listed below are present:

• HD NetVu onsole

• 24Vdc PSU

• Mains cables

• NetVu Console Keyboard

• USB Mouse

• Quick Start Guide

• External Storage Setup Guide

• Installation and Operation Guide (CD)

If any of these items are missing, please contact Dedicated Micros Technical Support team.

Note: Before installing the unit, carefully read all Safety Instructions and the following information

on where the unit should be located.

Choosing a location for installation

• Ensure the unit is properly ventilated to protect from overheating.

• Ensure the unit is not located anywhere it could be subject to extreme

mechanical shocks.

• The unit should be located in an area with low humidity and a minimum of dust.

• If the unit is to be installed in a closed assembly, the maximum operating temperature

must not exceed 40°C (104°F).

Electrical Connections

Please ensure the following are available and have been tested prior to the installation:

• Mains point (recommended)

• Network point

• Network cable

• Active video signals i.e. at least one working camera feed

• PC with CD ROM drive and connection to the same network as the HD NetVu Console

unit