Installation guide

79
NV1
Installation Guide
79
Remote codec When selected, the unit will utilise the codec in
the remote NetVu connected video server/camera
as if it was directly connected inside the DVR.
Thus the user can change Multimode proles and
perform additional activities such as VMD and
Activity Detection as if the codec was an integral
part of the DVR. If ‘Remote codec’ is selected,
the loading on the unit’s internal codecs will be
reduced.
IMPORTANT: The Remote codec option is only applicable for NetVu Connected cameras.
Note: Additional IP cameras (further to existing local camera channels) are remote codec only.
Therefore any NetVu Connected cameras will be applied above local camera level.
When ‘Simple Stream’ and ‘Recode Stream’ are selected via ‘IP Mode’, the following options will
be available:
URL Enter the URL address of the image source.
Port If required, edit the port input data. This will default to 80 (HTTP).
Chan If required, edit the channel input data.
PPS Edit the PPS (Pictures per Second) recording settings.
Recode Select to activate the recode option.
When ‘Remote Codec’ is selected via ‘IP Mode’, the following options will be available:
IP Address Enter the URL address of the image source.
Channel If required, edit the channel input data.
IP Camera (Yellow) Select to open the Camera->IP Stream Inputs page.
Camera (Blue) Select to open the Serial->Camera page.
Refresh (Purple) Refreshes the information on the current page.