Installation guide
74
HD NetVu Console
74
Remote codec When selected, the unit will utilise the codec
in the remote NetVu connected video server/
camera to allow change Multimode proles and
perform additional activities such as VMD and
Activity Detection as if the codec was an integral
part of the DVR. If ‘Remote codec’ is selected,
the loading on the unit’s internal codecs will be
reduced.
IMPORTANT: The Remote codec option is only applicable for NetVu Connected cameras.
Note: Inputs 1-4 can be analogue camera, Remote Codec, Simple Stream or Recode stream.
Inputs 5-8 can be Remote Codec only.
When ‘Simple Stream’ and ‘Recode Stream’ are selected via ‘IP Mode’, the following options will
be available:
IP Address Enter the URL address of the image source.
Channel If the URL is a multichannel device (e.g. HD NetVu Console), this
species which channel to use.
Both types
Live Trans (Red) Select to open the Network->Live Trans page
View Prole (Green) Select to open the Record Settings->Prole Record page
Basic (Yellow) Select to open the Serial Ports->Camera page.
Lens Setup (Blue) Select to open the Camera Lens Conguration page
Refresh (Purple) Refreshes the information on the current page.