Installation guide

72
HD NetVu Console
72
Type The settings will default to ‘Colour’. If Monochrome cameras
are used, select ‘Mono’. Selecting ‘Mono’ will remove colour
patterning. Select’ ‘IP’ for an IP Camera. If a particular channel is
not in use or the camera has failed, select ‘No Conn’.
IMPORTANT: The menu options displayed will differ depending on the camera ‘Type’
selected here.
Fail Rep Select this option to generate a Failure report in the event of
camera connection failure.
Telemetry If a telemetry capable camera is connected, the appropriate
control protocol should be selected from the accompanying drop
down list, refer to ‘Appendix G’ for details of supported
telemetry protocols.
Default to preset If a telemetry camera has been assigned a preset position, select
the chosen preset position here. Enter the time period (in minutes)
of inactivity which will result in the camera moving to its preset
position, For guidance on assigning camera presets refer to
Viewer menus->Program Page.
after X mins Refer to ‘Default to preset’.
Note: The following settings will change depending on the type of camera connected.
If a Local Analog Camera is selected
Colour Select a colour value from -8 to +8 via the slidebar or enter a
number directly into the accompanying textbox.
Brightness Select a contrast value from -8 to +8 via the slidebar or enter a
number directly into the accompanying textbox.