Installation guide

HD NetVu Console

Note: When a telemetry protocol is selected, these settings will default to pre-determined values

and should not normally be altered.

Protocol This is a drop down list of serial telemetry protocols supported by

the unit.

Note: Refer to ‘Appendix G’ for a full list of supported telemetry protocols.

IMPORTANT: Before the serial port is set to telemetry, ‘Enable 485 telemetry’ must be set to

‘True’ via the Features menu (System Settings->Features). The unit MUST be reset

to reassign the RS485 BUS to the serial port because it is assigned to the 485 Bus

controller by default.

Important: Conguring the Serial Port for Telemetry will disable the NetVu Console keyboard.

Reset (Red) Select to cycle the power to the unit.

Maintain (Green) Select to open the System->Maintain page

Camera (Blue) Select to open the Camera Conguration page (see below).

Refresh (Purple) Refreshes the information on the current page.

Camera Conguration

This page allows conguration of some features on all cameras available to the unit.

Update local sys cong on save Select to update and enforce any changes made here in the local

system display.

Camera Nuisance Count This is a repetitive detector value. When a camera failure alarm

is received on the unit, it will store the alarm time and monitor

the number of times the same alarm is triggered within an hour

period. If the detector is triggered the number of times entered

here, the unit will set the camera to ‘No Connection’. To disable

this feature, leave the setting as ‘0’.

Title Titles assigned to each camera are displayed.

Mode The settings will default to ‘Colour’. If Monochrome cameras

are used, select ‘Mono’. Selecting ‘Mono’ will remove colour