Installation guide
27
NV1
Installation Guide
27
System Settings
The menus under the System Settings heading allow the unit’s core settings to be viewed, changed
and the system software upgraded.
IMPORTANT: Not all menus will be available in both ‘Console’ and ‘Encoder’ mode. The mode
of operation can be selected in the Features->System menu (System Settings
->Features->System).
The Attributes option displays details about the unit including the IP address, unit serial number,
MAC address and software version.
The Status pages displays information about the unit’s operating condition, shows how long the unit
has been operating and the reason for the last reset. It also shows camera status and displays any
failed cameras. The About / Logs menus allow access to numerous system information pages and
detail various system logs.
The Language page allows the system language to be set. The language can also be changed for
the current session only.
The Time and Date page allows the unit time and date settings to be adjusted, including setting
the time-zone.
The Serial Ports page allows each of the two serial ports to be individually congured for one of a
range of operations, including, debug, PPP and telemetry.
The Features page allows control of the different features that are available within the software
including switching modes, E-mail reporting, webcam support and control of the display resolution.
The Maintain page allows the current conguration to be saved, and for previously saved settings to
be loaded. It also enables easy upgrade of the system software.
The PowerScript Mgmt page allows installed PowerScripts to be activated/deactivated on start-up.
The USB Cong. page allows one of the units USB sockets to be used as an external storage
output. A high capacity USB device could then be connected and used to store recorded
video images.