Installation guide

16
HD NetVu Console
16
Step 3 - Connecting to the Network
KBD
SERIAL 1
ALARMS/RELAYS
NET 1 NET 0 POE
PWR
IN
The HD NetVu Console supports two 10/100Mbps auto-detecting network port (operating on an
internal switch). Use a CAT5 cable to connect the unit to the network.
The unit also supports Power over Ethernet (PoE). This allows the power for unit to be supplied
via the ethernet port. If the PoE function is to be utilised, connect the CAT5 cable to the network
connector labelled ‘NET 0 POE’.
Note: The PoE function must be used in conjunction with a PoE Switch or the POE Injector
(not supplied).
POE Injector (available separately)
The Dedicated Micros POE Injector is designed to enable the use of POE (Power over Ethernet)
before a POE capable switch has been installed. It is installed alongside a suitable 48Vdc PSU that
can supply 15W is required - DM/PSU/48V can be purchased separately from Dedicated Micros.
A Connection to DVR/NVR/Switch
B Connection to suitable 48Vdc 15W PSU - (DM/PSU/48V)
C Ethernet cable connection to HD Console.