Installation guide
123
NV1
Installation Guide
123
Email
Note: Greyed menu option will be available if the mode is changed from Console to DVR
or Encoder, they are not available in the Console conguration. They are included for
reference only.
The unit can automatically transmit an email to an SMTP Server under numerous conditions i.e. on
start up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmanned
applications where a Remote Video Response Centre (or Manager etc.) would be notied by email if
any of these conditions occur.
Connection Prole It is possible for the e-mail to be transmitted via the Ethernet
network or dial up connection (PPP ‘Point to Point Protocol’).
This setting presumes that a modem has been connected or
congured and the unit is connected to a LAN or WAN and
allocated a valid IP address.
Mail Server Address This is the IP address or URL of the SMTP Server that the e-mail
will be sent to. The SMTP server will then forward this to the
intended recipient.
Username Enter the login details for the email account used above.
Password Enter the login details for the email account used above.
Recipient Email This is the e-mail address of the intended recipient.
Recipient Display Name This is the addressee name that will be shown in the e-mail
name eld.
Reply to E-mail This eld must be congured if the recipient is to reply to an
e-mail. The unit does not accept incoming emails therefore ensure
this is a valid e-mail address.
Reply To Display Name This is the ‘reply to’ name that will be shown in the e-mail name
eld.