Setup guide

Eco

How to Conﬁgure Video Inputs and Standard Record Settings

Each of the video inputs on the unit can be individually conﬁgured.

This section will describe the full conﬁguration process including resolution and ﬁle size, camera

titles, setting a camera to mono, camera fail notiﬁcation and standard recording settings.

1. Select Cameras -> Camera Set-up

2. It is possible to identify the global camera resolution (common to all video input) the current

option sets the resolution to 704 x 256.

3. Select the required image resolution, enter a ﬁle size of between 2K & 45K.

Note: See the Setup Guide for the recommended settings.

4. All connected cameras will be automatically enabled, use this screen to check the enabled

inputs are correct.

5 In the corresponding title box enter the camera name for the video source connected to that

input.

6. Use the drop down box to select whether alarm input polarity is Normally Open, Normally

Closed or Off for each camera alarm.

7. By default the unit presumes all enabled inputs are colour video sources. If you are

connecting a monochrome signal to the unit, it is recommended that the input be set for

mono. Place a tick in the corresponding video input.

8. To enable the unit to send notiﬁcation that the video input does not detect a 1V peak to

peak signal place a tick in the box below Cam-Fail Reporting. This can send a camera fail

email.

9. Save the conﬁguration by clicking the Save icon.