Setup guide

Eco

Simple Conﬁguration

How to Conﬁgure Global Parameters

There are some parameters that can be set that will affect the overall system; video standard for the

video inputs, browser format for the web interface, language that the menus will be displayed in and

the DST (daylight saving time) settings.

To conﬁgure these parameters:

1. Select Home -> Main Set-up.

2. Select the video standard from the drop down list; this will be the standard for all the video

inputs on the unit.

Note: It is necessary to carry out a system reset if the video format is changed before saving the

settings. This allows the unit to activate the change.

3. Select the date format from the drop down list.

4. The unit web pages can be viewed in two formats; Active X (default) or Java, select the

relevant option from the drop down list.

5. The web conﬁguration pages for the unit can be displayed in a selection of languages,

select the language which is most appropriate to your installation from the drop down list.

Note: Ensure the PC being used for the conﬁguration is set to the correct time zone and that DST

is enabled before continuing.

6. Select the DST for region where the unit is installed from the drop down list.

7. If the settings are incorrect reset the unit by selecting the reset button.

8. If the unit time is to be synchronised to the PC that is being used to conﬁgure the system

then select sync unit time from PC. Note this only synchronizes the time when the button is

selected this will not maintain synchronisation permanently.

9. Remember to save the conﬁguration by selecting Save Settings!

2.0003