Setup guide

Eco

How to Protect or Un-protect Images

Images stored on receipt of an alarm can be automatically protected within the corresponding alarm

conﬁguration page.

In addition it is possible to protect images that are stored on the hard disk and have not been

protected, or increase the time period allocated for protecting the image.

Alternatively it is also possible to highlighted protected recordings and un-protect these so they can be

overwritten.

To protect existing recorded images:

1. Select Alarms/Activity – Alarm Image Protect/Unprotect, If there are any existing protected

images these will be displayed within the protect image partition summary.

2. Enter the start and end time and date and select Protect Images to display the

corresponding recordings.

3. Highlight the recorded ﬁle in the protect image partition summary.

4. Enter the time period that images are to be protected in the protect image option or select

protect images indeﬁnitely for these never to be overwritten.

4.00021

To unprotect existing protected images:

1. Select Alarms/Activity – Alarm Image Protect/Unprotect

2. If there are any existing protected images these will be displayed within the protect image

partition summary, enter the start and end time and date to display the corresponding

recordings

3. Highlight the recorded ﬁle in the protect image partition summary

4. Select un-protect images, this will remove the protection from the ﬁles, release the hard disk

space these ﬁles where stored in and the ﬁles will now be overwritten.