Setup guide

Dedicated Micros ©2006
19
Eco
Function Description
Enable Email This will switch the function on or off.
Connection Profile It is possible for the e-mail to be transmitted via the Ethernet
network or dial up connection. This setting presumes that a
modem has been connected and configured and the unit is
connected to a LAN or WAN and allocated a valid IP address
Mail Server This is the IP address or DNS name of the SMTP Server that the
e-mail from the unit will be sent to. The SMTP server will then
forward this onto the recipient
Recipient This is the e-mail address and display name of the intended
recipient of the e-mailed image
Reply to This field must be configured if the recipient is to reply to an
e-mail. The unit does not accept e-mails so this must be a valid
e-mail address
Sender These optional fields indicate the source of the e-mail notification.
If the fields are left blank the unit will use the system name
& DNS Email reports This enables the user to select which
conditions will generate an email report, and allow selection of the
accompanying image to be sent in the email. It is also possible
to select whether Activity or Alarm event from each camera will
generate an email, or select all cameras for Activity or Alarm.
Email Reports This creates an email for each system, start-up, global alarm and
camera fail.
Activity/Alarm Each camera can be individually selected to send an email when
there is either Activity or Alarm or both. Click on the appropriate
checkbox to enable or disable each option.
4.00011