Operating instructions

Eco4

Add Still Image This will record a still image of the trigger along with the standard

recording. This can then be sent on to an external destination.

Email Image If this option is selected, a JPEG will be added to the reporting

email (if Email Reporting is selected).

Protect alarm Images

Alarm images can automatically be protected from

being overwritten

Goto Preset It is possible to action a telemetry camera to automatically be sent

to a preset position when an alarm is triggered.

Email Reporting The unit can send an email when an alarm is detected, refer to

‘Network->Email’ for further information.

Alarm Rate Change Select to change to the alarm mode recording rate on zone action.

Activity Inhibit Select to inhibit (ignore) the Activity detection feature, refer to

‘Alarm Settings->Activity Setup’ for further information.

System Set Select to change to the ‘Set’ mode recording rate on zone action.

Enable Buzzer Select to activate the unit’s internal buzzer upon alarm receipt.

Relay Select an onboard or external relay to automatically close on

receipt of an alarm.

Relay Duration Enter (in seconds) how long the relay is to remain closed.

Alarm Image Snapshot Delay This gure allows a delay to be introduced before an alarm

snapshot is taken. This is used when the alarm relates to a PTZ

camera which has to travel to a preset position.

Play audio message Following a Zone alarm trigger, a specic audio message

can be played.

IMPORTANT: Audio messages must be uploaded to the unit in mono 8k wav format only.

The following naming convention must be used: messageXX.wav

i.e. message00.wav, message01.wav etc.

An FTP client should be used to place the wav les in the following folder:

\mdd0\messages folder.

Switch Main Monitor Select to display the alarm zone Primary camera on the

Main Monitor.

System Override Select to force the unit to utilise the Override (Weekend) settings

(congured on the Schedule page) when the zone alarm is

triggered. The system will remain in this mode until the Schedule

switches.

Note: This label may have been edited in Schedule->Setup

Preset Camera The preset camera is the camera which will be sent to a

designated preset position upon alarm activation.

Preset Enter the preset position number for the selected camera here,

refer to the individual camera documentation for more information

on establishing camera preset positions.

Cam Options (Yellow) Select to open the Zone Action Camera Conguration page (see

below).

Intelligent Security & Fire Ltd