Operating instructions

Eco4

Serial Ports

This menu allows conguration of the unit’s Serial connection. Refer to ‘Installing the Unit’ for

installation information.

Serial Port These are two serial ports available.

Note: Each D type connector can be utilised by two serial connections by assigning RS232 and

RS485 to the same connector. A cable will have to be created that connects the relevant

output pins to the correct device.

Port Cong The serial ports can be congured to specic uses.

Select from:

None Switches port off

Debug Sets port for serial communications

PPP Sets port for Point to Point Protocol

Telem Sets port for Telemetry purposes

Comm Sets port for Comms purposes

General Sets port for general purpose

connections

LED Box Sets the port for connection to a

LED Status Box.

Note: It is recommended that Serial port 1 be set for ‘Debug’ operations.

Interface Type Choose the type of serial interface being used. Select from

RS232, RS485 or RS422.

Intelligent Security & Fire Ltd