Operating instructions

DV-IP RT

Installing the Unit

Before you start

Check the contents of the box

Remove all items from the packaging and check the items listed below are present:

• DV-IP RT (either 8, 16 or 32 input)

• IR Remote Control

• IR Remote Control Extender

• USB Mouse

• Power Leads

• Rack mounting brackets

• DV-IP RT Software disc

• DV-IP RT Installation & Operation Guide

• Quickstart Guide

If any of these items are missing, please contact Dedicated Micros Technical Support team.

Note: Before installing the DV-IP RT DVR, carefully read all Safety Instructions and the following

information on where the unit should be located.

Available Accessories

The following accessories can also used in conjunction with the DV-IP RT:

• KBC1 Keyboard

• KBC2 Keyboard

• Managed Storage Unit - Extend storage capacity

• Managed Continuous Archiving - Mirrored RAID1 storage unit

• Congurable 8 disk RAID system (default is RAID5)

For further information about any of the above products, please contact Dedicated Micros customer

services in your region.

Choosing a location for installation

• The DV-IP RT is designed to be desk, shelf or rack mounted.

• Ensure the DV-IP RT is properly ventilated to protect from overheating.

• Ensure there is a 3cm gap on both sides of the unit.

• Ensure the receiving end of the IR remote control extender faces the operator position

and is not more than 3 metres (10 feet) from the operator.

• Ensure the unit is not located anywhere it could be subject to mechanical shocks.

• The unit should be located in an area with low humidity and a minimum of dust. Avoid

places like damp basements or loft spaces.

• If the unit is to be installed in a closed assembly, the maximum operating temperature

must not exceed 40°C (104°F).

• Ensure there is reliable earthing of the mains outlet when tted to supply connections

(other than direct connection to the branch circuit).

• Any branch circuit supplying the unit must be rated at 15Amps.

• It is recommended that an uninterrupted power source be connected to the unit in case

of power failure (to ensure continuous operation of the unit).