Operating instructions

Dedicated Micros ©2009
119
DV-IP RT
Point&go
Point&go enables an Oracle Dome camera to be controlled directly via the mouse. Click anywhere
on the displayed image and the Oracle dome camera will centre on that point i.e. to pan the camera
to the right, click on the right hand side of the displayed image. The Oracle dome will pan and set
the clicked point as the centre of the new image.
Note: To use Point&go, PTZ mode must be selected (if available).
Note: Oracle dome cameras can also be controlled using the Joystick / Directional Control
Buttons on the DM KBC1 / KBC2 Keyboards.
Telemetry Command Options
Telemetry commands can be activated directly via the Telemetry Command symbols. To access the
modes and options featured below, roll the USB mouse over the camera symbols displayed in the
upper right of the screen. The modes available will depend on the camera type being accessed.
Note: The symbols shown below will only be displayed if viewing via a local monitor and not
the webpages
Symbol Mode/Camera Type Options Available
Fixed Camera
eZoom Use this option to zoom into areas of the image. The camera itself is
not being directly controlled. Use the mouse to select a point on the
image. Use the + and - symbols illustrated below to zoom in / out.
ePTZ mode Use this option to zoom into areas of the image. The camera itself is
not being directly controlled. Use the cursor to select a point on the
image. Use the + and - symbols illustrated below to zoom in / out.
Zoom IN / OUT When displayed, use these buttons to zoom in / out of the image.
PTZ Mode Use this option to directly control an Oracle dome camera via the
Point&go feature. Rolling the mouse over the icon will display more
Telemetry command options (detailed below).
To cycle through these options, click on the currently displayed symbol
i.e. click on the Zoom symbol to display the
Iris option.
PTZ Zoom When displayed, use the + and - symbols to utilise the camera’s Zoom
function.