User manual
DV-IP User Manual v1.01 Feb 28
th
2003
DV-IP User Manual
43
S
S
p
p
e
e
c
c
i
i
f
f
i
i
c
c
T
T
a
a
s
s
k
k
s
s
Recording to PC or network storage
To record the footage being viewed, be it live or recorded, follow the steps below:
1. If you want to capture recorded footage, either rewind to the desired time, or use the Instant Go-To
fields.
2. Once you have reached the desired time, click the Record button in the controls
3. This brings up the Record Options – in there you can select the
type of video you wish to record as – either M-JPEG, Raw AVI, or 2
resolutions of AVI. Once this is selected, recording will start if you
are viewing live footage. If you are viewing replay footage, you
need to press the Play button to start the recording.
4. To stop recording, press the Record button again.
5. The recorded file can now be found on your PC desktop. To play
back the footage, use the DV-IP VCR programme bundled with
your unit.
Setting up Telemetry Control
Coaxial Telemetry
The DV-IP Supports coaxial telemetry for PTZ cameras and Domes using Pelco or BBV compatible Coax
protocols.
To set up coax telemetry, follow the instructions below:
1. Enter the Config pages
2. In the System Menu, select Serial Ports and Telemetry
3. In the Telemetry Type pulldown menu, select Coax(BBV/Pelco)
4. Save the page, then reset the unit to store the settings. The unit can be reset by pressing the reset
button
5. Go back to the Config menu
6. In the Cameras Menu, select Camera Set-up
7. On the Camera Set-up page, select the type of telemetry desired from the Coax Telemetry column
which should now have appeared.
8. Save the page
9. Go to the System Menu, then to Reset and reset the Unit
10. Your changes have now been applied. Go to the camera set for telemetry and test the functionality.
RS232 Telemetry
RS232 Telemetry can be used with the following Matrices: Ademco(VCL), American Dynamics, BBV. The
DM * Commands protocol is also available.
1. Enter the Config pages
2. In the Cameras menu, in Camera Set-up, ensure no cameras are set with Coax telemetry
3. In the System Menu, select Serial Ports and Telemetry
4. In the Telemetry Type pulldown menu, select the relevant telemetry type
5. Select a serial port using the radio button next to the relevant COM number, then change the
pulldown option to Telemetry