User manual

DV-IP User Manual v1.01 Feb 28

2003

DV-IP User Manual

Physical Set-up

Please ensure the following are available and have been tested prior to the installation:

• Mains point

• Network point

• Network cable

• Active Video Signals e.g. at least one working camera feed

• Desktop or Laptop PC with CD-ROM drive and connection to the same network as the DV-

IP unit

To rack-mount the unit, screw the supplied rackmount brackets onto the front sides of the

DV-IP and mount the chassis into the rack. For desk or shelf mounting, the adhesive feet

supplied should be stuck to the base of the unit.

Connect the video signals onto the top row of the BNC connectors on the rear of the DV-IP.

Note that the first video channel is enabled by default, so it is advisable to connect a camera

to this input.

The second row of connectors allows for loop-through connectivity to other pieces of

equipment. Cameras routed to other equipment in this way should be set to ‘unterminated’.

The default setting is terminated. This can be altered in the Camera Set-up configuration

page

Connect the PSU to the power input on the rear of the unit. Please ensure the PSU is

connected to the unit BEFORE applying mains power. Then apply mains power. The power

LED should light up green.

Now follow the instructions below to set-up your unit.