User manual

DV-IP User Manual v1.01 Feb 28
th
2003
DV-IP User Manual
16
Schedule
This page provides a 7-day system Control Timer. This allows for timed schedules e.g. The
unit could be switched to alarm-only recording at 5.30pm every day when work finishes.
Day - Provides an automated alarm system configurable Sunday through Saturday.
Alarms-Set - The time (in 24 hour clock i.e. 17:00 is 5pm) when the DV-IP alarms become
active.
Alarms-Unset - The time when alarms become inactive.
Alarm State: - Enabled (Set) or Disabled (Unset). The alarms can be enabled by the
Schedule, Alarm Input 17 (Keyswitch) or controlled by both.
Schedule Enable - Enables the schedule, acting on the times entered in the fields for each
day.
Schedule Recording – This schedules recording of the cameras. If this is ticked, once the
page is saved the recording will operate based on the schedule settings. Additional fields will
appear in the Standard and Variable Rate
Recording pages.
These allow 2 separate recording schedules to
be established for each camera – 1 profile for
periods where the Alarms are set, and a
different one for when Alarms are unset. In
the Variable Rate Recording page, this means
that 6 different recording rates can be defined
for each camera, dependant on the situation.
System Set/Unset - Provides a keyswitch
environment that allows manual switch-on of
the DV-IP alarms. If the system is left Unset,
the times specified in schedule will override
the system to activate the alarms. Schedule
Enable must be ticked for this feature to work.