Operating instructions
Dedicated Micros ©2008
21
DV-IP Server
Conguring the Unit
The unit can be congured either on the local monitor or over the network using a PC with Internet
Explorer or similar browser. Both have near identical menu interfaces.
Accessing the menus on a local monitor
Note: If the IR Remote Control does not open the conguration menus, press the DVR button to
make sure it is in DVR mode, then press the MENU button again.
Accessing the menus on a PC web browser
Locating the Unit IP address
Note: The unit can be installed in a DHCP network environment where an IP address, subnet
mask and default gateway will automatically be allocated from the network DHCP Server
(DHCP is enabled by default).
Note: If a DNS �Domain Name Server address is not to be used, it is strongly advised that a xed�Domain Name Server address is not to be used, it is strongly advised that a xed
IP address be assigned �a DHCP assigned address can change without notication i.e.
following power failure).
A xed IP address can be assigned via the Network Settings:-Network menu.
Default DNS Address
It is recommended that a DNS �Domain Name Server address be congured. Assigning a
recognisable name can help a remote user to locate the unit.
machine serial number.yourdomain.com
• <machine serial number> is displayed in the System menu page
• <yourdomain> is the name assigned to your
yourname.yourdomain.com
yourname
Note: To activate an assigned DNS address, it will be necessary to reboot the unit. The DV-IP
Server can be rebooted via System Settings:Maintain:- Reset.
IMPORTANT: To set the time and date on the unit, navigate to System Settings:-Time and Date.