DS2 Setup Guide
Dedicated Micros ©2007
92
DS2
Important Installation Information
Warning: The rear supports must be used when rack mounting the unit. Failure to do so may cause
damage to the unit.
The ambient operating temperature must not exceed 40°C (104°F). Special care should be taken if
the unit is being installed in a closed or multi-unit rack assembly.
Ensure the unit is not mounted in a position that could obstruct cooling airow.
The unit case is ventilated. These openings should not be blocked or covered.
When stacking units, ensure there is at least a ½” (1.5cm) between each unit.
Ensure there is a 1” (3cm) gap on either side of the unit.
If the unit is to be mounted in a rack, ensure all the supports are mounted level with each other to
avoid twisting the case.
Ensure the mains socket outlet is reliably earthed, particularly when using supply connections other
that direct connections to the branch circuit.
Any branch circuit used for the unit must be rated at 15 Amps.