DS2 Setup Guide
Dedicated Micros ©2007
87
DS2
VMD Grid
The VMD grid covers 16 default areas of the screen, it is possible to congure the grid to only cover
the areas of interest.
Note:
Ensure the camera to be congured has been selected prior to highlighting the Setup
option.
When Setup is selected a prompt is displayed. Follow the instructions on screen to congure this
option.
To edit the VMD grid;
1. Move the ‘*’ to the start point of the zone to be created. Use the 7 or 8 to move between the
default zones.
2. Press Camera 1 to switch to ‘drawing’ mode and to automatically delete the existing (if
applicable) zone (see on-screen text to check the drawing option is selected).
3. Use the arrow keys to move to the end point for the zone (this will be diagonally opposite
the start point to create a box).
4. Press Camera 1 to take the unit out of the drawing mode.
5. You can press Camera 2 to cycle through the modes available and select the mode that is
to be applied to the created zone. This is the same as setting the VMD Zone mode.
Use direction keys to navigate grid
Use Camera 1 key to set selected zone
Use camera 2 key to cycle through zone modes
Use << and >> to change between zones
Press MENU/MODE key to start setup
Press MENU/MODE key again to exit grid
VMD Test
Once the VMD Camera Settings have been congured, it is possible to test the conguration.
When Walktest is selected, a prompt will be displayed. Follow the on-screen instructions.
If the settings are not satisfactory, adjust the settings and then carry out the walktest again.
Note:
If the Walktest fails consistantly, check that the Nuisance Count and Stuck Time settings
(within General Contacts) are suitable for this operation.