DS2 Setup Guide

Dedicated Micros ©2007
72
DS2
Event destination
Download options
Clear video protection
Watermark partition
Download on demand
FTP
Scheduled
Disabled
Enabled
Start
00:01
FTP, CD/DVD
Disabled, Enabled
Disabled, Enabled
Polled, 000 - 999 min, Manual only,
On connection, On full CD/DVD
A
utomatic Archivin
g
Event Destination
This identies where the images will be sent. The options available are:
• CD/DVD - This will store the images to a local CD/DVD writer.
• FTP - Images will be transmitted to an FTP Server via FTP.
Note:
When FTP is selected it will be necessary to congure the FTP settings for the unit. For
further details on conguring Automatic Archiving to an FTP Server refer to the Network
Guide.
FTP Settings - Forced archive
If a system policy is in place it may be necessary to archive any recorded images within a set
time, the forced archive option can be congured to ensure the recordings are archived within this
specied time period.
If a system policy is in place it may be necessary to archive any recorded images within a set
time, the forced archive option can be congured to ensure the
recordings are archived within this specied time period.
FTP Settings - Warn threshold
It is possible to set a threshold on the unit so that if the archive process is slower than the recording
rate the unit can identify when the selected percentage (example is set to 30%) of hard disk space
that is not waiting to be archived remains before the un-archived images will be overwritten. This will
allow the Operator to either slow the record rate down or review the speed of the archive process.
FTP Settings - Start Date
There are two options:
Start at - This allows the time and date to be congured. It is possible to start the archive
process in the future stating all recordings after this date will be archived, or in the past to
ensure previous recorded images plus all new recordings are archived.
No change - This will leave the date as previously congured (or from when the Continuous
Archive option was enabled).
FTP Settings - Archive Date
This is a read only setting and shows the time and date of the last archive session and identies
what the percentage of recorded images are left to be archived i.e. 100% means the archive process
hasn’t begun and there is still 100% of recorded images to be archived.
This percentage will be used in conjunction with the warn threshold, as the percentage drops (as
les are archived) the unit will monitor and will trigger an event when the percentage drops below
the specied threshold.
Download Options
The download option determines when the download will occur, the available options are: