DS2 Setup Guide

DS2

System Options

Unit number

System name

Factory default

System Resolution

IR Receiver

Serial & telem ports

System logs

Status page

Registration

DS2

Reset

720x512

Enabled

Edit

01 - 16

Enabled, Disabled

ystem

ption

Unit number

When multiple units are connected together via the 485-bus, a unit number must be set to identify

each unit.

Note:

Modifying the unit number will disable control via a remote keyboard. The new unit number

should be selected to regain control of the unit.

System Name

Each unit can be allocated a relevant 20 character name to identify the unit to the Operator or

System Administrator. This will display on the LCD display of a connected remote keyboard.

Factory Default

This will switch the majority of the settings back to factory default. However hardware specic

settings such as the IP address, camera termination, etc. will remain unchanged.

System Resolution

This is the fundamental resolution for the system and will be used as the basis of all the congurable

resolution parameters described in this document.

The supported system resolutions are: 640x512, 640x576, 704x512, 704x576, 720x512, 720x576

(PAL) or 640x480, 704x480, 704x544, 720x480, 720x544 (NTSC).

IR Receiver

If multiple units are being controlled from the same IR remote control, it is necessary to disable the

IR reception on all but one unit to allow communication between the handset and the system.The

remote control mimics the front panel control of the unit and allows control of a single or multiple

units (use the unit select option). However the remote control does not allow the conguration of the

menus, or control of telemetry cameras.

When the IR receiver is enabled the IR LED on the unit is solid green, when it is disabled the IR LED

switches to solid amber. The LED ashing green signies an IR signal being received.