DS2 Setup Guide

DS2

Zone NOT Input

The unit will only issue the alarm actions if the trigger is received on the zone alarm input and not on

the Zone NOT input. The allocated alarm trigger can be any of these options; Aux, Module 1, VMD,

Presets, System.

Notes on Zone Alarm Input, OR, AND, NOT Inputs

The following example shows how the unit uses the OR, AND and NOT settings when all three

parameters are congured:

Example

With the functions set to the following alarm inputs:

Base Input (Alarm Input) = Aux contact 1

OR input = Aux contact 2

AND input = Aux contact 3

NOT input = Aux contact 4

Result = [(Alarm1 OR Alarm 2) AND Alarm 3] NOT Alarm 4

The example translates into; an alarm must be received on input 1 AND input 3 but NOT on input 4

OR an alarm must be received on input 2 AND input 3 but NOT on input 4.

Be aware if an alarm is received on input 4 under the above circumstances the event will not be

triggered.

Zone Actions

This identies the actions that will be allocated to the zone being congured.

Note:

The actions are spread over three pages.

Zone on entry route

Zone on exit route

Entry initiator

Exit initiator

Text only Alarm

Enabled

Disabled

Enabled, Disabled

Zone

1 Actions

Page

This will scroll through all the available actions, there are three pages of actions. Use the or

buttons to scroll through the pages.

Zone on Entry Route

This is part of the Advanced Alarm Features and will create deferred alarms while the entry time is

active in compliance with BS8418, the British Standard for remote monitoring stations.

There will be specic alarm areas associated with the entry route, if someone enters the specied

alarm areas during the entry count down process the alarm will not be triggered allowing the

operator to reach the keyswitch to switch the system into an operating mode where the deferred

alarms are disabled. Diverting from the entry route during the count down will result in the alarm

being triggered immediately.