DS2 Setup Guide

DS2

Alarm Exit Timer

The exit timer is the time allocated to allow the key holder time to leave the premises once the

keyswitch has been activated, if the alarm system detects a presence after the exit timer elapses

then alarms will be triggered.

Forced Day, Night, Weekend

The unit supports three operating modes which by default are set as Day, Night and Weekend. Each

operating mode can be congured with different recording and alarm settings. This option enables

the ‘Force’ buttons on the unit web interface to be active allowing a remote user (with the correct

username and password) to access the unit via the web pages and force the unit into another

operating mode for a set time period

Tip:

For more information on the web interface refer to the unit Networking Guide.

Alarm Zone Cong

An alarm zone logically groups alarms and initiates actions when an alarm is activated. Each Alarm

Zone can be individually congured within this menu.

Zone

Zone 01 Activation

Zone 01 settings

Zone 01 actions

Primary camera Zone 01

Select zone 01 camera

030 sec

Disabled

000 - 999 sec

Selected cameras, All cameras

larm Zone

onfi

uratio

Zone

There are 32 zones that can be individually congured and allocated actions. Use the or

buttons to scroll through the zones.

Pre-Congured Zones

There are a number of pre-congured zones that have the following functions, however these can

be re-congured if required.

• Zone 1 to 16 - Camera Alarms.

• Zone 30 - Disk Low.

• Zone 31 - Disk Full.

• Zone 32 - Panic Alarm.

Zone Activation

Each zone can be scheduled to be always enabled (24Hr) or individually activated during the day,

night and at weekends.