Setup guide

50
ENGLISH
50
VMD Test
Once the VMD Camera Settings have been configured, it is possible to test the
configuration.
Note: VMD must be enabled on the selected camera for the Walktest option to
selected.
When Walktest is selected, a prompt will be displayed. Follow the on-screen
instructions.
If the settings are not satisfactory, adjust the settings and then carry out the
walktest again.
Press MENU / MODE key to start walktest
Press MENU / MODE key again to exit
Note: This menu is only displayed if ‘Text in Image’ has been enabled in the
‘Record Options’ menu.
The Digital Sprite 2 supports the option to include text information, received
from a peripheral device, alongside the recorded video. The images can then
be searched on the text data, for review via web page.
Camera
Each camera can be individually configured. Select the relevant camera by
pressing the corresponding camera key.
Number of Lines
This is the number of lines that will be displayed in live and replay using the
OSD (On-Screen Display) on the main monitor, along with the relevant images.
The default setting is 20 lines.
Width of Lines
This identifies the length of the lines that will be stored with the image. The
default setting is 50 characters, which is generally the full screen.
Text Colour
It is possible to select which colour the text from the peripheral serial device
will be displayed within the image.
The options are; Black, White, Yellow, Magenta, Red, Cyan and Green.
Text Insertion Setup
Text Insertion Setup
Camera 1
Number of lines 20
Text colour White
Width of lines 50
Text background Off
00-20
01-50
Black, White, Yellow, Magenta, Red,
Cyan, Green
Off, White, Black