Setup guide

44
ENGLISH
44
Title
Each camera can be allocated a title. Use the and buttons to scroll
through the available characters.
Input termination
Termination can be set On or Off.
Note: Termination must be ‘Off’ for cameras that are looped through to other
devices.
Camera type
This option allows you to select the camera type, colour or mono.
Colour adjust
When the colour adjust option is selected, use the buttons to adjust the
colour.
Contrast adjust
When the contrast adjust option is selected, use the buttons to adjust
contrast.
Camera Setup
Camera Setup
Input termination
Camera 1 - Detected
Camera type
Colour
On
--------|-------
--------|-------
Connected
Colour adjust
Contrast adjust
Camera video input
Connected, Disconnected
On, Off
Colour, Mono
Title Camera 1
None
Telemetry type
None, Serial 1, Serial 2,
Bus A, Bus B
Camera video input
This option allows faulty cameras to be taken out of the ‘Camera Fail’ option,
or disconnected cameras to be disabled.
Select ‘Disconnected’ if the camera is no longer present and will not be replaced.
Select the ‘Connected - Ignore Cam Fail’ option if the camera is temporarily
offline to prevent the camera fail message and alarm being triggered.
Tip: The Camera Setup menu can be directly accessed by pressing and
holding any of the camera keys.
Telemetry
The Digital Sprite 2 supports control of coaxial and serial telemetry. This option
allows the connected dome/PTZ camera to be configured.
Ensure the serial type has been selected in the ‘Serial and Telemetry’ menu.
This option then allows these settings to be allocated to specific video inputs.
The options available are:
• Serial 1 - Selected RS-232 protocol (default disabled).
• Serial 2 - Selected RS-232 protocol (default disabled).
• Serial 3 - Selected Bus A RS-485 protocol (default Dennard).
• Serial 4 - Selected Bus B RS-485 protocol (default Pelco).
• Coax - Pelco.
• Coax - Dennard.
• Coax - BBV.
• None - Camera does not have an associated serial device.
Use the or buttons to scroll through the available options.
Note: The settings shown are an example of the options available.