Setup guide

26
ENGLISH
262626
PPP IP
Enter the IP address allocated to the PPP functionality. Use the and
buttons to scroll through the available numbers.
PPP Idle Line Timeout
This is the time the Digital Sprite 2 will wait before disconnecting the PPP link if
no data is being transmitted or received.
PPP Link Down Timer
This is the time the Digital Sprite 2 will wait before dropping the PPP
connection should it be lost.
Secondary Web Server Port
The Digital Sprite 2 can be configured to send video via a web port. If the
standard web port (80) is already utilised on the network, it is possible to
configure a secondary web server port.
To view the device, via a web browser, using the secondary web port, you will
need to enter the following in the internet web address section or the Digital
Sprite 2 viewing software;
http://<IP Address of the Digital Sprite 2>:<secondary web port number>
For example of the secondary web address allocated is 8000, with an IP
address of 172.16.1.2 then the entry would be: http://172.16.1.2:8000.
Primary DNS
The Digital Sprite 2 supports Domain Name Server allowing the unit to
reference other devices by their name rather than the IP address. Enter the IP
address of the primary DNS server.
PPP Selection
PPP IP 010.001.001.241
PPP idle line timeout 180 Seconds
PPP link down timer 02 Minutes
Disabled, Enabled
000 - 500 Seconds
00 - 60 Minutes
Secondary DNS
The Secondary DNS Server is a back up server in case the primary server
fails. Enter the IP address of the secondary server.
Remote Reporting
The Digital Sprite 2 supports remote alarm monitoring and can configured to
automatically carry out actions to notify the remote station of events. This
menu configures the remote reporting.
Note: It is recommended that the Remote Reporting feature be configured via
the Web interface, refer to the Networking Guide for full configuration
information.
Email Settings
If the Digital Sprite 2 has been configured to transmit e-mails on alarm, camera
fail, etc. It is necessary to configure the e-mail settings.
Note: It is recommended that the Email Settings option be configured via the
Web interface, refer to the Networking Guide for full configuration information.
SMS Settings
The Digital Sprite 2 can be configured to send SMS messages under specific
circumstances; alarm, system startup, etc.
This menu allows the SMS settings to be configured to allow the messages to
be transferred to the SMS Server.
Note: It is recommended that the SMS Setting option be configured via the
Web interface, refer to the Networking Guide for full configuration information.
Web Cam Settings
Any of the video inputs on the Digital Sprite 2 can be made available and
transmitted via FTP to a web serving device. These images can then be
incorporated into a web page and accessed via a standard web browser.
Note: It is recommended that the Web Cam Settings be configured via the
Web interface, refer to the Networking Guide for full configuration information.