Setup guide

Alarms and Presets

Alarms and Presets Camera XX Detected Not Detected

Telemetry protocol None B B V, Pelco, DM, (serial telemetry dome)

Preset Module Contact Input

> -- 01 01 N/O

> -- --

Camera XX

The currently selected camera number is displayed, along with its status –

detected or not detected. Press a camera key to select a camera to configure

alarms and presets for that camera.

Telemetry protocol

Select the telemetry protocol for the camera; BBV, Pelco, DM, or the serial

telemetry dome selected in the ‘System Options’ menu page.

BBV and Pelco is Coaxial telemetry, if you are using Pelco serial telemetry it is

displayed as ‘Pelco-P’. DM telemetry is twisted pair DTMF telemetry (using a

TAD3) or 485-Bus telemetry.

Note: Autopan and patrol (tour) modes are not available when using Pelco

coaxial telemetry.

Notes for JVC domes: If you are using JVC domes there are two types of serial

telemetry, type 1 and type 2. Select the correct type to correspond to the model

number from the list below:

Type 1 Type 2

T K - C 6 7 5 E T K - C 6 7 5 B E

T K - C 6 7 5 U T K - C 6 7 5 B U

T K - C 5 5 3 E

Preset

If the camera has telemetry presets configured, these can be recalled when

an alarm is triggered. Enter the preset number from 00 to 99 for the selected

alarm contact.

Module

Select the address of the alarm module being used, up to 16 alarm modules

can be connected to the 485-bus network, the default setting is alarm module 1.

Contact

Each alarm module has 16 alarm inputs, each input can be used by any camera

or multiple cameras.

Input

Select whether the alarm contact on the alarm device is normally open (N/O)

or normally closed (N/C)

7211 DigitalManual Update 10/4/02 5:12 pm Page 25