Setup guide

24
Title
Each camera title can be up to 12 characters long.
Input termination
Termination can be set On or Off. Termination must be off for cameras that are
looped through to other devices.
Camera type
Cameras are detected automatically, to change the camera type choose colour
or mono.
Colour adjust
When the colour bar is selected, pre s s to reduce, and to increase the colour.
Note: this option is not displayed if the camera is set as monochrome.
Contrast adjust
When the contrast bar is selected, press down to reduce, and up to increase
the contrast.
Camera video input
This option is only displayed when a camera has failed or is offline. Select
disconnect whilst the camera is offline to prevent the camera fail message and
alarm being triggered.
Tip: This menu can be entered directly by pressing and holding a camera key.
Camera Set-Up Title CAMERA 1
Input termination On Off
Camera type Colour Mono
Colour adjust
Contrast adjust
Camera video input Connected Disconnected
Camera SetupSystem Options (Continued)
Timed expiry
Images recorded onto disk can be programmed to expire after a user-defined
number of days and hours. This option is useful if you are required to adhere to
legislation on maximum recording time, for example, 31 days.
Wa rn i n g : Once the timed expiry has been set, all images older than the selected
time will be lost.
Serial telemetry
The Digital Sprite 2 has an RS-485/232 serial telemetry port on the rear of the
unit. At the time of writing this port supports the following domes:
Ultrak Ultradome™ KD6
Ademco / VCL Orbiter and Jupiter Microsphere™
JVC TK-C675, TK-C553E
Dennard 2050
Panasonic WV-CS850, WV-CS854
Aritech / Kalatel CyberDome™
Sensormatic Speeddome™ V
Pelco P Spectra II
Select the type of telemetry from the list to configure the Serial telemetry port.
Each dome will need to be configured for serial telemetry and addressed correctly.
Refer to the dome manufacturers documentation for details, alternatively a
s u p p l e m e n t a r y document for using domes on Digital Sprite 2 digital re c o rders is
a v a i l a b l e for download from our website or by request from our Technical Support
department at [e-mail]
Note: Once the Serial telemetry is selected, the telemetry type for each camera
must also be selected in the ‘Alarms and Presets’ menu page. Only one type of
serial telemetry is permitted per machine.
7211 DigitalManual Update 10/4/02 5:12 pm Page 24