Setup guide

20
Activity Setup
Pre-activity
Pre-activity images can be recorded for a pre-set time prior to an activity event.
Select the number of minutes or seconds (30 min 59 sec maximum).
Note: Pre-Activity Recording only occurs if standard recording is taking place.
Post-activity
Post-activity images can be recorded for a pre-set time after an activity event.
Select the number of minutes or seconds (30 min 59 sec maximum).
Auto copy
Activity events can be automatically copied to an external Zip
®
or Jaz
®
disk.
Extended relay
This option allows activity detection on each camera to trigger an individual relay
using an external relay module (DM/CI02/16). Each module has 16 relay outputs,
each one assigned to camera 1 to 16. For example, when activity is detected on
camera 1, relay 1 will close on the external relay module.
Relay 2
The second relay can be configured to activate when activity detection and/or
camera fails are detected. Select whether the relay will close or open when
activity is detected.
Activity display
By default, the last camera with activity detection is not displayed on the main
monitor. Select ‘Yes’ to display cameras with activity.
Activity buzzer
The buzzer built into the Digital Sprite 2, and the external keyboard can be
triggered when activity is detected by selecting ‘Yes’.
A c t i v i t yS e t U p Pre-activity 00 min 00 sec
Post-activity 00 min 02 sec
Auto copy No Yes
Extended Relay Off Module 01 ...Module 16
Relay 2 Activity, Cam fail, Both, None Close, open
Activity display No Yes
Activity buzzer No Yes
Alarm relay (R1)
Choose whether the alarm relay (R1) will open or close when an alarm is
activated. Selecting Momentary open or Momentary close will open or close the
relay for a duration of half a second regardless of the alarm length.
Alarm buzzer
The buzzer built into the Digital Sprite 2 and the external keyboard can be
triggered when an alarm is activated by selecting ‘Yes’.
Camera fail buzzer
The buzzer built into the Digital Sprite 2 and the external keyboard can be
triggered when a camera fail is detected by selecting ‘Yes’.
Note: The camera fail buzzer will continue to activate until the failed camera is
reconnected or replaced. To deactivate the camera fail buzzer on the failed
camera, press and hold the corresponding camera key to enter the Camera Setup
menu and disconnect the camera video input.
Alarm Setup (Continued)
7211 DigitalManual Update 10/4/02 5:12 pm Page 20