Setup guide

Page 80 Dedicated Micros
Function Description
Enable PING response
from server
By default this option is enabled and allows the Digital Sprite 2 to be
pinged. Disabling this option will make the unit less visible on the
network.
Allowed IP address These are the IP addresses and subnets that the server will allow
connections from, i.e. the IP address of the host PC’s that will
connect to the Digital Sprite 2 to; review video, download
information.
Note: If you enable this function ensure the IP address of the PC you are using to configure
the system is also in the list. If the address is not added then you will be unable to
communicate with the Digital Sprite 2 via the network, it is important to take this feature into
account when the unit is on a DHCP network, where IP addresses are allocated automatically.
If no IP addresses are specified than any IP address can connect to the Digital Sprite 2.
Open TCP ports
This list identifies the TCP ports that are on the system and
available. If a host tries to communicate with the Digital Sprite 2
using a TCP port that is not in the list, even with a valid IP address,
the host will not gain access to the unit.
The enabled ports can be a range or single port address, if a single
port is needed then enter the same port number in the to and from
section.