Setup guide

Dedicated Micros Page 79
3. Enable the PING response option by placing a tick in the adjacent box. Disabling this feature
will make the Digital Sprite 2 less visible on the network.
4. Enter the IP addresses that can have access to the unit, these can be a range of addresses
or a single IP address.
If there is a range of address then enter the first IP address in the sequence followed by
/nn where nn is the last IP address in the range. Refer to IP Address and Subnet
Calculation below.
5. Enter the subnet of the network, if a subnet has been specified in the IP address then that
will take precedence over this subnet.
6. Identify the TCP ports that are enabled and available on the Digital Sprite 2, enter the same
number in the To and From values if a single port is required.
7. Enter the UDP ports on the system that are available, enter the same number in the To and
From values if a single port is require.
8. Save the configuration by selecting Save Settings!
Note: If you attempt to use a port that is not in the list, even if you have a valid IP
address you will not gain access to the unit.
Note: If you attempt to use a port that is not in the list, even if you have a valid IP
address you will not gain access to the unit.
Note: For configuration via the OSD refer to Appendix G where all menu options are
described.