Setup guide

Page 70 Dedicated Micros
How to Protect or Un-protect Images
Images stored on receipt of an alarm can be automatically protected within the
corresponding alarm configuration page.
In addition it is possible to protect images that are stored on the hard disk and
have not been protected, or increase the time period allocated for protecting the
image.
Alternatively it is also possible to highlighted protected recordings and un-protect these so they
can be overwritten.
To protect existing recorded images:
1. Select Alarms/VMD – Alarm Image Protect/Unprotect, If there are any existing protected
images these will be displayed within the protect image partition summary.
2. Enter the start and end time and date and select Protect Images to display the
corresponding recordings.
3. Highlight the recorded file in the protect image partition summary.
4. Enter the time period that images are to be protected in the protect image option or select
protect images indefinitely for these never to be overwritten.
Function Description
Reply to This field must be configured if the recipient is to reply to an e-mail. The
Digital Sprite 2 does not accept e-mails so this must be a valid e-mail
address.
Sender These optional fields indicate the source of the e-mail notification. If the
fields are left blank the Digital Sprite 2 will use the system name & DNS
name to create a sender name.
Email reports These are the conditions under which the Digital Sprite 2 will transmit
and e-mail; when the Digital Sprite 2 has been reset, when an alarm
zone has been triggered, if any of the video inputs has detected camera
failure, if VMD has been identified on any of the enabled video inputs.
Email Logging A log can be created for every e-mail transaction that the Digital Sprite 2
issues.