Setup guide

Dedicated Micros Page 65
To configure the SMS information to allow a text message to be transmitted on receipt of an
alarm:
1. Select Network -> SMS-Setup.
2. Enter the GSM destination number of the mobile phone, this should be entered in
international format including the country code.
3. It is possible to make the Digital Sprite 2 into an SMS Server by enabling the SMS Server
option. If this has been enabled then you need to enter the destination URL or IP address of
the Digital Sprite 2. This will allow the message to be sent from a Digital Sprite 2 to a Digital
Sprite 2.
4. Enable the operations that are applicable to your application; Report startup, alarm, camera
fail, and VMD activation.
5. Verbose messages must be enabled to ensure the text message is in a human readable
format. Tick the box adjacent to the relevant function.
6. Enter the callback profile in 0 and 1, this is the route the text message from the Operator will
take when sending a message back to the Digital Sprite 2.
7. Enter the password to enable SMS commands to be initiated. This password will be
included in the text message from the Operator.
8. Select the advanced setup button to enter details on the GSM module that will be used in
the system.
9. Enter the service centre number, this is the network service centre number of the mobile
phone, this information can usually be found on the phone in Messages -> Message Settings -
> Profile -> Message Centre Number based on a Nokia phone menu.
10. Enter the pin number for the SIM card (if applicable).
11. Enter the GSM/SMS port number that will be used for this function to operate on.
12. Remember to save the configuration by selecting Save Settings!
Note: If a pin has been set the number must be entered each time changes are
made to this page and is submitted (Save Settings).
Note: For configuration via the OSD refer to Appendix G where all menu options are
described.