Setup guide

Page 64 Dedicated Micros
If the Operator is remote they can send a message back to the Digital Sprite 2 to action the
Server to send an alarm message to a remote viewing application. The Digital Sprite 2 will
send a message to the remote monitoring station which includes the information in the text
it has received.
The remote station can then access the Digital Sprite 2 to acknowledge and action the
alarm.
To enable the serial port for the SMS feature:
1. Select System -> Serial Ports & Telemetry.
2. Using the drop down list on the associated Communication port (Serial 1 if dial on alarm is
enabled) select PPP.
3. Select the relevant modem from the Modem/TA drop down list, if your modem is not
supported then you will need to add the modem to the modem.ini file.
4. The serial standard settings for the selected modem will automatically be allocated,
however if this is incorrect you can change these for:
- Baud rate, Parity, Data bits, Stop bits, Flow control.
5. Remember to save the configuration by selecting Save Settings!
To edit the modem.ini file for modems which are not identified in the drop down list of
supported modems:
1. Using an FTP client application connect to the Digital Sprite 2.
2. Locate the \etc directory and expand.
3. Locate the modem.ini file.
4. Highlight and press the right mouse button, select edit.
5. Enter the information for the GSM Modem being used, an example of the information is
shown below:
[N30HSCSD]
name=Nokia30HSCSD
reset=AT&F
init=ATE0&C1&D2S0=1+CMGF=1;+CBST=16,0,1
save=AT&W
negate_dtr=0