Setup guide

Dedicated Micros Page 57

An example of the profiles file is shown below:

# —————————-

# Profiles Table List

# —————————-

The username will also be the profile information that will be entered in the web interface page.

6. Save the file and upload back onto the Digital Sprite 2. You will now need to add this

information to the Alarm/VMD Reporting page via the web interface.

7. Reset the Digital Sprite 2.

To configure the remote alarm station information using the web interface:

1. Select Alarms/VMD -> Alarm/VMD Reporting.

2. Enter the IP address of the primary remote host, this is required for connections via the

network and via the serial ports.

3. When making a connection via the Ethernet network enter Ethernet to identify the medium by

which the connection will be made. Alternatively for dial up connections via the modem enter the

username previously configured in the ‘profiles’ file, the example above would result in the

profile entry being dm.

4. Enter the IP address of the secondary host; this is in case the primary host can not be

contacted.

dm password PPP_Link2

1234567890

10.0.0.1 255.255.255.0

username password PPP_Link2 1234567890 10.0.0.1 255.255.255.0

test password PPP_Link2 1234 10.0.0.1 255.255.255.0

Note: The username and password must be unique and they will both be case

sensitive.

Note: It is possible to identify the host information, as displayed on the web page,

within the hosts file in the \etc directory.