Setup guide

Dedicated Micros Page 53
How to Configure the Relay Connections
The Digital Sprite 2 supports a number of onboard relay connections and can
also integrate additional relay modules via the 485 bus connection.
These relays can be triggered under specific conditions; on receipt of an alarm,
notification of VMD, etc or they can be permanently allocated for set functions.
This section details how to enable the default actions for a number of the on-board relays.
Relays 1 to 3 can have pre-configurable global options enabled.
To enable the default relay settings.
1. Select System -> Relay Setup. There are three default settings that can be enabled which
are directly linked to a relay.
2. Relay 1 can be configured to trigger when any of the alarm zones that have been configured
are triggered. Tick the corresponding box.
3. Relay 2 can be configured to be triggered when VMD has been activated on any of the video
inputs that are enabled in the VMD page. Tick the corresponding box.
4. Relay 3 can be configured to trigger when any of the enabled video inputs does not detect a
1 volt peak to peak video signal and therefore detects camera fail. Tick the corresponding box.
5. Save the configuration by selecting Save Settings!
Note: If any relays are enabled for the default settings the corresponding relay test
option will be removed from the Close Relay list in the Alarm Zone page, refer to the
previous section for more information.
Note: If the defaults are not set this allows the onboard relays to be available to be
automatically triggered on alarm, this is configured within the Alarm/VMD -> Alarm
Zone option.