Setup guide

Page 46 Dedicated Micros
10. The zone NOT input allows you to configure a situation where if an alarm is received on the
zone alarm input then an alarm must not
be received on the zone NOT input to force the
Digital Sprite 2 into alarm mode which will initiate the alarm actions configured, select the
appropriate option from the drop down list.
11. Remember to save the configuration by selecting Save Settings!
Function Description
Alarm image
protect period
This is the time period in days that the alarm images will be protected
from being overwritten, when this time period elapses the images will be
automatically overwritten.
Note: When protecting an image it is important to remember that the
Digital Sprite 2 saves files in 50 Megabyte blocks, the whole block that
contains the image will be protected. If the image overlaps into another
block the all associated blocks will be protected this can start to reduce
the hard disk capacity available for storing images. To unprotect images
refer to System -> Protect/Unprotect Images.
Protect alarm
images indefinitely
Protecting the alarm images indefinitely will ensure the alarm images are
never overwritten .
Note: This section must be used in conjunction with System ->
Protect/Unprotect Images.
Select Alarm Zone
An alarm zone logically groups alarms and initiates actions when an
alarm is activated, there are 32 zones that can be configured.
Note: There are a number of zones which have been pre-configured;
Zone 30 Disk Low, Zone 31 Disk Full, Zone 32 Panic alarm.
Zone Title This information is stored along with the images in the database, ensure
this has relevance to the alarm trigger. There is an option to use the
camera title.