Setup guide

Page 40 Dedicated Micros
19. If you want to use the default zone settings you can select the default grid option, this will
place 16 zones over the image. You will be presented with a prompt, select Yes.
20. Select the zone mode from the drop down box that will apply to the zone you have selected
see below for description of zone modes.
21. Set the pixel count (%) by selecting from the drop down box the range is between 2 and
100%.
22. Set the pixel change (%) by selecting a value from the drop down box the range is between
2 and 100%,
An example of VMD operation:
Select the ‘zone area’ that will be configured and set the ‘pixel count’ to 20%, this determines
the percentage of pixels, in the selected zone, that must change for VMD to be triggered. Set
the ‘pixel change’ to 10%, this is the percentage value of the overall change required in the
greyscale.
23. To check you have covered the areas that you want to monitor for motion you can select to
view the zone areas only, select zone display only and you will be presented with the areas
you have highlighted.
24. Selecting full display will show the whole image.
25. Remember to save the configuration by select Save Settings!